
The Sendzimir process
The Edison of metallurgy from Lviv
✦ Confirmed
President Mościcki walked into a zinc plant near Katowice and could not believe it: “This is not a zinc plant, it is a sanatorium.” There were no toxic fumes there.
Who: Tadeusz Sendzimir · When: 1929–1989 · Where: Katowice, USA
The tale
Tadeusz Sendzimir (1894–1989) graduated from Lviv Polytechnic. After the First World War he made his way through Vladivostok to Shanghai and set up a factory there making bolts, wire and nails.
In 1933 in Kostuchna, today a district of Katowice, he started up the world's first line that annealed and galvanised steel sheet in a continuous process. There was no need to pickle the sheet in acid, so there were no toxic fumes in the hall.
A year later his rolling mill started up at the Pokój steelworks, reducing the thickness of sheet from 6 millimetres to 0.1 millimetre in a continuous process. Companies from France, England and the USA bought licences.
The war found him in America and he stayed there. He held 120 patents, 73 of them in the USA. He also invented the planetary rolling mill, which in a single pass turns a block 200 millimetres thick into sheet 2 millimetres thick. In communist Poland he was long left out of encyclopaedias.
How it works
- A clean surface: The sheet passes through a furnace with a gas that removes oxides. It does not need to be cleaned with acid.
- A bath of zinc: The hot, clean sheet goes straight into molten zinc and is covered with a thin layer that protects it from rust.
- Rolling under tension: The sheet is at once squeezed between rolls and stretched. This makes it possible to beat it out very thin in one continuous run.
Check for yourself
- Zinc flowers: Look closely at a galvanised bucket, gutter or fence post. You can often see a pattern on it like frost or flowers. These are zinc crystals that have solidified on the sheet.
- A nail in salt water: Put an ordinary nail into one glass of salt water and a galvanised one into another. Compare after a week. The ordinary one rusts, the galvanised one much more slowly.
- Rolling out under tension: Roll out modelling clay once in the ordinary way, and once holding its end and pulling gently. With tension it is easier to get a thin, even sheet.
What is known for certain
The Sendzimir process is today the standard for galvanising sheet all over the world. In the early 1980s over 90% of the world's stainless steel passed through his rolling mills.