Enter the forest
The walls of Sacsayhuamán
Lost secrets of the masters

The walls of Sacsayhuamán

Stones fitted so tightly that not even a knife blade will go between them

◐ Under study

Above Cuzco stand walls of blocks weighing over a hundred tonnes. Each polygonal stone fits its neighbours like a piece of a puzzle. For centuries people have asked how it was done without iron or the wheel.

Who: The Inca builders · When: 15th–16th century · Where: Cuzco, Peru

See the illustrated storyphotos, animations and experiments to do yourself

The tale

Sacsayhuamán is a fortress and ceremonial site above the Inca capital. Three terraced walls zigzag along a length of about 400 m and are about 6 m high. The heaviest block weighs, according to various estimates, from 128 to almost 200 tonnes.

The stones have a dozen or so edges, and yet they touch over their whole surface without mortar. The walls lean slightly inward and the corners are rounded. Thanks to this they survived strong earthquakes in Cuzco.

Legends have grown around them: of a plant juice that softens stone, of the pito bird that bores holes in rock, and of technologies from lost civilisations. The chemist Helmut Tributsch proposed in 2017 that the stonemasons could have smoothed surfaces with mud containing acid from bacteria, but that is only a hypothesis.

The architect Jean-Pierre Protzen of Berkeley tested it more simply: he took stone hammerstones from a river and himself worked blocks in an Inca quarry. It turned out that stones can be shaped and fitted this way. On the walls the marks of blows can be seen, and beneath them chips. The Spanish chronicler Bernabé Cobo described the ramps by which the Inca hauled stones.

How it works

  1. Hammerstones: Hard river stones are struck against the block, knocking off tiny chips. The edges form slowly, but very accurately.
  2. Trial fitting: The block is lifted, the contact mark with its neighbour is checked, and the bulges are worked down. This is repeated until the fit is perfect.
  3. Ramps and ropes: Heavy stones were dragged up earthen ramps on ropes and wooden beams. This took hundreds of people and good organisation.

Investigation: facts and theories

Documented

Theories

What we don't know: Exactly how long the construction took and how many people worked on it. Exactly how the largest blocks were raised to the higher terraces.

Check for yourself

  1. Fit the potatoes: Cut two raw potatoes into irregular lumps. Rub one face with blackboard chalk, press it against the other and scrape off with a paring knife the places where a mark was left. Repeat until they fit together along the whole face.
  2. A wall without mortar: Build a 30 cm high little wall from flat garden stones without any glue. Tilt the sides slightly inward and shake the table. Compare with a little wall with vertical sides.
  3. How much a block weighs: Limestone weighs about 2.7 tonnes per cubic metre. Calculate how much a stone the size of your room would weigh.

What is known for certain

The hammerstone working method is confirmed by experiments (Protzen, 1983) and by marks on the stones. Traces of ramps are visible at other Inca structures. The stone-softening theory has no confirmation, and the gloss on some surfaces can be explained by a calcite deposit.

Why it was lost: The Inca had no alphabetic writing, and after the conquest the Spaniards pulled down a large part of the fortress for building material. The knowledge of the master stonemasons was not written down.

Sources