
Bonsai · project
Bonsai from a nursery tree
A cheap tree from a garden centre (e.g. a juniper) can be the start of a bonsai. Such material is called pre-bonsai (a tree prepared for further shaping).
Step by step
- Choose a tree with a thick trunk and branches low near the ground. A tree with a long bare trunk is hard to turn into a bonsai.
- Brush back the soil at the trunk and find the nebari (roots at the base). In nurseries they are often buried under a few centimetres of soil.
- Turn the tree and choose the front: nice roots, a nice trunk, the tip leaning slightly towards you.
- Cut out dry, dead twigs. Then the trunk and branches are easier to see.
- Choose the first branches: one lower on the side, a second higher on the other side, one at the back. Remove branches that grow straight towards the viewer.
- If necessary, shorten the tip. But do not remove too many leaves at once - a juniper draws its strength from its needles.
- Wrap a few main branches with wire and position them lightly.
- Put the tree outdoors in a bright spot, shelter it from strong sun and wind, and water when the soil dries out slightly. Repot into a smaller pot only next spring.
Sources
- Bonsai cultivation and care - Wikipedia
- How to make a bonsai from nursery stock - Fire Escape Bonsai
- Juniper nursery stock... repot or style first? - Bonsai Nut
- Styling juniper after repotting - Mirai forum
- Should I mess around with styling after I repot my juniper - Bonsai Nut
- Repotting - Bonsai Empire
- 26 years in: juniper transformation - Bonsai Empire